Threaded Probe
Threaded Probe are widely used especially in the automotive sector and for testing connectors. They have the particularity of having a threaded barrel at one end. In addition, a square or hexagonal milling on the collar facilitates screwing into the receptacle.
All these characteristics have been studied to allow the right housing even in particular working conditions and to avoid any possible displacement.
The installation pitch of the Threaded Probe ranges from 2.54mm to 4mm.
The current rating of our Threaded Probe ranges from 3A to 8A but can be increased if the customer requests different technical characteristics.
The typical resistance of Threaded Probes ranges from 20 mΏ to 30 mΏ.
The high quality of the raw material that we use to make all our products allows us to continue to achieve very high quality standards.
The materials and plating processes used for Threaded Probe are:
The receptacles for Threaded Probe are special because they have a thread inside that allows the Probe to be fixed.
The material used is brass, which is then gold plaated.
to weld the wire directly in the receptacle
Often when using Threaded Probes in the automotive sector it is necessary to use plungers with collars.
We offer our customers a wide range of shapes and collars, with different heights and diameters.
On request, it is possible to produce all kinds of milling, the most commonly used are:
Call us!
+39 045 602 0916
Email us!
This email address is being protected from spambots. You need JavaScript enabled to view it.
Fill the form!
To get a quick response
Via Alessandro Volta, 16
37024 Arbizzano di Negrar VERONA Italy
+39 045 602 0916
This email address is being protected from spambots. You need JavaScript enabled to view it.
Tecon srl | P.IVA 03780900233 | REA: VR-365047 | Cap. Soc. € 60.000 i.v.
Privacy Policy